Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet. Hi, I’m Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks. In this video, we’re going to show you how to service the bulbs as well as replace the entire outer taillight assembly on this 2005 Volkswagen Jetta. We show you on the passenger side, but the driver side is the same procedure. It’s the same part and similar process on these Jettas from 2005 to 2007. The items you’ll need for this procedure is a new outer tail light from 1AAuto.com, and a 10mm socket and ratchet. On the back of your tail light in the trunk you’ll see these flaps. Just pull this back. Then push up on the tabs on the socket assembly. Then the sockets will pull out. To service the bulbs, you just push in and twist it counterclockwise and it will pull out.Take your new bulb, push it in, and twist it clockwise to lock it in. This bulb’s the same procedure. Then you just push those back into place. If you’re looking to replace the entire assembly, just push the tabs on this harness, disconnect it from the socket, and put the sockets aside. Then remove these two 10mm nuts. We’ll just fast-forward as Mike does that. Now pull the tail light assembly free. On the left is the old tail light assembly; on the right is the new one from 1A Auto.You can see you’re identical and they’ll fit exactly the same. Take your new tail light and feed back into place. We’ll fast-forward as Mike replaces those two 10mm nuts and tightens them up. Now reconnect the harness to the sockets. Then push the sockets back into the tail light. Close this flap, and you’re all set. We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We’re the company that’s here for you on the Internet and in person. .